Firmware Stock Bitmain

1. You must use a flash drive or SD card with a capacity of up to 16GB and must format it in FAT32 format. It is not recommended to use an SD card with an OTG adapter for AMLOGIC control boards instead of a flash drive.
2. Unpack the archive for your type of control board into the root of the flash drive (SD card).
3. Connect an SD card or OTG adapter with a flash drive to the turned off miner.
4. Turn on the power of the miner and wait for the green LED on the front panel to light up (and remain constantly lit) miner This will mean that the firmware process was completed successfully. This process takes no more than one minute.
5. Turn off the power of the miner and remove the SD card or OTG adapter with a flash drive from the control board.
6. Turn on the power of the miner and wait for it to load, then use HASHCORE-TOOLKIT install Vnish firmware.